Firmware & Updates

USB Limit Fix

The Cambrionix USB Limit Fix is a free application for Mac which can increase the number of USB devices which you can connect to a computer running MacOS.

This is particularly useful if you are required to manage batches of say 30/32/40/48 tablets at one time with Cambrionix products.

The USB Limit Fix is only required for certain Apple Mac computers which use the Intel Core i5 and Core i7 processors. These processors are also known by the Intel codename of ‘Haswell’.

The USB Limit Fix application will install the fix so that it is always enabled on every boot without the need to run the application. There is an option to uninstall the USB Limit Fix within the USB Limit Fix application itself.

ChaSync+

ChaSync+ is a service for Apple computers to enable higher charging rates for iOS devices in sync mode when ChaSync is not enabled or supported (such as with the older 30 pin connector). For iOS devices with lightning or USB Type-C connectors, ChaSync will enable charging at up to 1.5A.

Disabling ChaSync and installing ChaSync+ will enable charging at up to 2.1A for iOS devices when in sync mode. Up to 2.1A charging is always available in charge mode for all iOS devices irrespective of ChaSync being in use or ChaSync+ being installed.

Command Line Updater

The command line updater is a stand-alone application, for host computers connected to supported hardware, that provides the ability to update firmware that is released by Cambrionix.

This application simplifies the deployment of firmware, and the update experience whilst minimizing user interaction.

This application can also be used to update firmware without the need for installing any software, supporting runtime libraries or changes to the Host operating system.

EtherSync Connector Software

EtherSync Connector software is used to connect a client computer to USB devices attached to a Cambrionix EtherSync.

EtherSync Firmware

EtherSync Firmware is the code that runs on the EtherSync units themselves.