Installing a Mac mini into the Boss module
One of the features of the Boss Module is the ability to install a Mac mini inside.
This provides different levels of sophistication to the ability of your device.
WARNING
Do not remove covers marked with this symbol.
High voltages may be present.


Tools needed
A screwdriver and a spanner (wrench) is needed for this job.
Step 1
Remove the screws using a screwdriver.
This is the view from below the device. There are eight screws to remove.
Next, remove the screws from the rear (second image).


Step 2
Slide the top of the Boss Module 4 inches, as demonstrated in the in the graphic.
The second graphic demonstrates how the product should look at this stage. Notice the highlighted yellow screws, which should all have been removed at this point.


Step 3
With a spanner (wrench), undo the highlighted nut below.
Once removed, it will allow you to slide the lid off fully.

Step 4
Once the lid is completely removed, it will reveal the inside of the product.
Next, remove the screws (highlighted in yellow) in order to remove the Mac mini chassis.

Step 5
Once you have removed the Mac mini chassis place your Mac mini on the circular mat (outsides highlighted below).
You can then attach the mini Mac to the three wires on the left (see arrows below).
The Mac mini power on button should align with highlighted yellow area on the diagram across.
Once the Mac mini is securely, reattach the Mac mini chassis and the side panels in the same order that they were removed.
You have now successfully installed your Mac mini into the Boss Module.

